New Page 1

Author Topic: Need for speed!  (Read 4259 times)

Panzermeyer

  • Guest
Re: Need for speed!
« Reply #25 on: October 01, 2012, 05:29:46 AM »
True it's the controller I'm worried about.  :o

Offline slowstartgjh

  • Sr. Member
  • ****
  • Posts: 270
  • Country: au
  • GO MAROONS and MBRCTC
Re: Need for speed!
« Reply #26 on: October 01, 2012, 05:43:52 AM »
did you go to master's to buy an apron then  ;D

Tankboy was right.
Tam Leopard 2A6
Elefant
2 X Tam M4 Sherman
3 X Tamiya King Tiger
Mattarro Jagdtiger
Tandy M4 Sherman
3 X HL Tiger 1
2 X Tamiya Tiger 1
2 X HL 1/30 M4
Taigen Tiger 1
Taigen Panzer IV
Asiatam top/bottom Tiger 1
2 X Torro T35/85
Hobby Engine M1A2 AU
Hobby EngineLEOPARD
HL KV-1
HL ZTZ
VS Leo

Diverfrost

  • Guest
Re: Need for speed!
« Reply #27 on: October 01, 2012, 09:49:07 AM »
Here is a quick fix for non waterproof controllers  ;D  ;D


Offline maxmekker

  • Able to Hull Down
  • *****
  • Posts: 703
  • Country: no
Re: Need for speed!
« Reply #28 on: October 01, 2012, 07:28:19 PM »
Just use a plastic bag over teh controller. Works a treat

Panzermeyer

  • Guest
Re: Need for speed!
« Reply #29 on: October 01, 2012, 08:54:51 PM »
Did the cooling line upgrade today. The cooling from factory, comes straight from the rudder, into the esc and then into the motor cooling jacket and then out of the boat. This meant that the motor water was already used to cool the esc. Now the water comes through a bigger borded line, from the rubber splits to cool the esc and motor seprately and then exits both rejoining to exit the boat togeather.Still haven't run her yet. Soooooon!!!!! ;)