New Page 1

Author Topic: KV 1 lower hull  (Read 255 times)

Offline biff131

  • Full Member
  • ***
  • Posts: 203
  • Country: au
  • Town/City: Abermain NSW
KV 1 lower hull
« on: September 15, 2016, 10:44:04 AM »
my kv lower hull and parts arrived safely and so did my abrams parts.
Due to my heavy handed approach (If it dont fit get a bigger hammer) I have broken the rear panel but I think a bit of JB weld will fix it (along with tape and clamps). The cast metal is very very weak and could do with upgrading to a higher quality casting metal.
I have also stuffed two return rollers so if you have a set return roller in stock can you send them. If you dont have a complete set I can get by with 2 return rollers for now until you get a set in. I will probably stuff some more so best have a few spares.
Besides those issues I am very pleased with the hull.
Thanks for your great service
Biff

Offline Mark

  • Administrator
  • Operation Greenline
  • *****
  • Posts: 835
  • Country: au
    • OzArmour
  • Town/City: Brisbane - Northside
Re: KV 1 lower hull
« Reply #1 on: September 15, 2016, 02:13:02 PM »
Anytime mate thanks for your support once again.
Also, thanks for letting me know about the rear panel. If possible, can you send me a pic of the rear panel so I can show the distributor.
I have had the road wheel sets on backorder for sometime and apparently, they will be in my hot little hands again sometime next month.
Cheers mate